Neat. How much work was it? Any thoughts about doing a How-to?

It was a lot of work to get it to fit because it’s not actually that deep. I managed to make it work by installing a longer cable for the display (it was too big with it in the normal position) and getting a 90° power adapter to allow the door to close. The filament spool is positioned on top and goes through a printed tube. There is also a small hole to allow cables to go out from the back. I could give instructions / answer questions if anyone is interested.

After all Said and done did you notice any print quality differences?

Yes, there was a big improvement. It stands under my window and the draft ruined a lot of prints. I struggled to print anything over 5 cm high.
Now the temperature inside is higher (temperature sensor inside says it’s 34 °C) and the humidity is about ~15% lower than the rest of the room. Print quality has improved a lot.

There is one inside. It’s visible in the first picture (on the left of the printer). There is also a temperature sensor attached on top.

A standard Docker container with a NodeJS/PHP/Python app is usually around 200-300 MB (yes really), the OpenJDK JVM is around a hundred MB, but a fully statically compiled rust binary that doesn’t even depend on libc is just a couple MB and can be deployed as a tiny distroless Docker container.

It’s a lot heavier than your 8kb C++ executable but it’s nothing compared to what is required to deploy anything else.

They had a hardware failure but close enough